FOCUS Enhancements Bridge/Router MX-4DV - Manual (Page 32)

MX-4 DV U SER G UIDE C HAPTER 3 28
Live Broadcast Configuration
This configuration is useful in a Live Broadcast environment.
1 Connect the VIDEO OUT from Camera 1 to VIDEO IN 1 (Y/C) on the MX-4 DV rear panel.
Connect the AUDIO OUTs from Camera 1 to AUDIO IN 1 on the rear panel.
2 Connect the VIDEO OUT from Camera 2 to VIDEO IN 2 on the MX-4 DV rear panel. Con-
nect the AUDIO OUTs from Camera 2 to AUDIO IN 2 on the rear panel.
3 OPTIONAL – Connect an audio source (CD player, tape deck, or microphone) to AUDIO IN
4 on the MX-4 DV rear panel.
4 Connect a Composite MV-4 -type monitor to the PREVIEW OUT jack on the rear panel.
5 OPTIONAL – Connect a GPI trigger device to the GPI CONTROL on the MX-4 DV rear
panel.
6 OPTIONAL – Connect a character generator (CG) to the OUT Y/C jack on the rear panel.
With this configuration you can superimpose titles from the CG atop the output signal.
7 Connect a recording VTR to the OUT Y/C jack on the rear panel.
If you are using the optional Character Generator (described above), connect the output from
the CG to the VTR input.
8 Connect the Output Monitor to the recording VTR so you can see the signal being recorded.
9 Connect the Power Cord and Transformer to the MX-4 DV rear panel. Refer to “Power Con-
nector” on page 22 for instructions.
Use the Route function (refer to page 73) to make sure your devices are directed to the correct MX-
4 DV channels.