FUJITSU DESKPOWER 6000 - Manual (Page 78)

68
Error Messages
This section provides a list of error messages and suitable responses thereto. Consult this
section as required.
○ ○ ○ ○ ○ ○
Error messages displayed by the PC
Error Message
An error occurred at address
xxxx during a system memory
test.
An error occurred at address
xxxx during an additional
memory test.
An error occurred during a
keyboard controller test.
An error occurred during a
keyboard test.
An error occurred during a
floppy disk drive test.
Description and necessary action
If an extended RAM module is used, remove the
module and determine whether the error recurs. If this
message is not displayed, an extended RAM module
error is expected. Replace with another extended
RAM module and determine whether the error recurs.
If the error recurs, contact a dealer or the your local
distributor.
Confirm that the extended RAM module is mounted
properly and is a Fujitsu product. If the error recurs,
contact a dealer or the your local distributor.
Set the MAIN switch to OFF, then wait ten seconds
and set to ON again. If the messages is still played,
contact a dealer or your local distributor.
If an external keyboard is connected, confirm that it is
connected correctly and turn on the power again. If
this message is still displayed, contact a dealer or the
your local distributor.
Confirm that ‘Floppy Disk Drive A’ is set properly on
the BIOS setup main menu and that the floppy disk
drive is mounted correctly. If this message is still
displayed, contact a dealer or the your local
distributor.