FUJITSU DESKPOWER 6000 - Manual (Page 100)

90
○ ○ ○ ○ ○ ○ ○
Cleaning a CD-ROM drive
The lens in a CD-ROM drive for reading data may become dirty after extended periods of
use, thereby preventing efficient reading of data from the CD-ROM. Use the CD-ROM
cleaning disk to clean the CD-ROM.
● Item to prepare
CD-ROM cleaning disk.
● Cleaning method
Before using the CD-ROM cleaning disk, remove the plastic ring fixed to the disk.
1
Switch on the PC.
2
Align the special cleaning brush on the rear of the CD-ROM cleaning disk
using a small brush included in the CD-ROM cleaning disk case.
3
With the red triangle facing you, mount the CD-ROM cleaning disk on the
tray until a click is heard.
4
Insert the tray.
5
Wait about 20 seconds.
Although unusual sounds may be heard or the disk may spin at high speed, the
PC is not defective.
6
Check that the BUSY lamp is off, then press the EJECT button to dismount
the CD-ROM cleaning disk.
7
Align the special cleaning brush of the cleaning disk to the hole on the
surface of the storage case.
8
Restart the PC.