FUJITSU DESKPOWER 6000 - Manual (Page 34)

24
○ ○ ○ ○ ○ ○ ○
Memory combination table
Install a memory module to DIMM1 and DIMM2. A memory module has been installed in
DIMM1 as standard. Check the combination of memory capacity and slot using the
following table to install the memory module. Using a combination other than below may
result in faulty operation of the PC.
○ ○ ○ ○ ○ ○
Installing an additional memory
1
Remove the upper cover.
2
Push down the hooks at both ends of
the slot.
Use a genuine Fujitsu part called “168-pin SDRAM DIMM (100 MHZ) memory” for this PC.
The PC may not work correctly if the recommended Fujitsu memory module is not used.
Point