FUJITSU DESKPOWER 6000 - Manual (Page 50)

40
Mode
This item appears when ‘Parallel Port’ is [Enabled]. Set the operating mode of the
parallel port.
- Output only
Select when connecting a peripheral unit using output mode only.
- Bi-directional (Initial value)
Select when connecting a peripheral unit using bi-directional mode.
- EPP
Select when connecting an EPP standard peripheral unit.
- ECP
Select when connecting an ECP standard peripheral unit.
I/O Address
This item appears when ‘Parallel Port’ is [Enabled]. Set the I/O address of the parallel
port.
- 378 to 37F, 278 to 27F, 3BC to 3BF (Initial value: 378 to 37F)
Interrupt
This item appears when ‘Parallel Port’ is [Enabled]. Set the interrupt number of the
parallel port.
- IRQ5, IRQ7 (Initial value: IRQ7)
DMA Channel
This item appears when ‘Mode’ is [ECP]. Set a DMA channel used to connect an ECP
standard peripheral unit.
- DMA 1, DMA 3 (Initial value: DMA 1)
● Keyboard/Mouse Features
This submenu is used to set up the keyboard and mouse.
Move the cursor to this item and press the Enter key to display a submenu as shown below.
F1 Help
↑↓
Select Item -/Space Change Value F9 Setup Defaults
ESC Exit
←→
Select Menu Enter Select : Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Info Exit
Keyboard/Mouse Features
Numlock: [ ON ]
PS/2 Mouse: [Enabled]
USB Legacy Emulation: [Auto]
Item Specific Help
Selects power-on
state for Numlock.