FUJITSU DESKPOWER 6000 - Manual (Page 55)

45
4
● Event Logging Configurations
This submenu is used to set up event logs.
Move the cursor to this item and press the Enter key to display a submenu as shown below.
– Event Log Capacity
This item sets whether event logs can be saved.
- Space Available
Event logs can be saved (up to 255 logs).
- Full
No more event logs can be saved. The area is full.
– Event Log Validity
This item displays whether the event log data is valid.
- Valid
Event log data is valid.
- Invalid
Event log data is invalid. Data may be destroyed.
– Clear all Event Logs
This item sets whether all event logs are cleared at reboot.
- No (Initial value)
Event logs are not cleared.
- Yes
Event logs are cleared. Clear all Event Logs’ is [No] at reboot.
– Event Logging
This item sets whether events are logged when they are generated.
- Disabled
Event logging is disabled.
- Enabled (Initial value)
Event logging is enabled.
F1 Help
↑↓
Select Item -/Space Change Value F9 Setup Defaults
ESC Exit
←→
Select Menu Enter Select : Sub-Menu F10 Save and Exit
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Info Exit
Event Logging Configurations
Event log Capacity: Space Available
Event log Validity: Valid
Clear all Event Logs: [ No ]
Event Logging: [Enabled]
System Boot Event: [Disabled]
ECC Event: [Enabled]
Item Specific Help
[Yes]
All event logs are
cleared at next boot.
The value is reset to
[No] after clearing.
[No]
Event logs are not
cleared.