FUJITSU DESKPOWER 6000 - Manual (Page 27)

17
2
○ ○ ○ ○ ○ ○ ○ ○
Mounting and dismounting a CD-ROM disk
● Mounting a CD-ROM
1
Press the EJECT button.
Pressing the EJECT button ejects the
CD-ROM tray from the drive.
2
Pull out the tray.
Pull out the tray as shown on the right.
3
With the label of the CD-ROM
disk facing up, place the
CD-ROM disk in the center of the projection
tray until it clicks.
Hold the tray so that the unit may not be
overturned.
4
Push the tray into the PC main unit until it clicks.
The tray retracts into the PC main unit and the CD-ROM is set.
- When the CD-ROM is set, the BUSY lamp goes on. When the BUSY lamp goes off, proceed
to the next step.
- Pressing the EJECT button when inserting the tray does not set the tray correctly.
● Dismounting a CD-ROM
To dismount a CD-ROM disk, confirm that the BUSY lamp is off, then press the EJECT button
as shown above.
Tray
EJECT button
BUSY lamp
Label side
Tray
Projection
Point