Furuno CH-250 - Manual (Page 86)

5-6
7. Press or to select PRESET KEY or SHORT-CUT KEY as desired.
8. Press the [MENU] key twice to register your selection and close the menu.
5.3.2 Preset key
1. Select PRESET KEY following the procedure in paragraph 5.2.1 on page 5-3.
2. Press the [MENU] key to open the menu.
3. Press to select MENU, and then press or to select PRESET.
MODE SECTOR TRAIN RANGE TILT SPEED
PRESENT
CUSTOM 1
CUSTOM2
CUSTOM3
FUNCTION KEY: ENTRY MENU: END
ADJUST THE KNOBS AND FUNCTION KEYS TO THE DESIRED SETTING,
THEN PRESS A CUSTOM MODE KEY TO SAVE THE SETTING.
240
°
360 °
180 °
360 °
160
160
120
160
FAST
FAST
FAST
NORM
30
°
30 °
90 °
30 °
0
°
0 °
90 °
0 °
MENU COM1 HORZ VERT ES PRESET SYS COM2
Figure 5-5 PRESET menu
4. Set the [MODE], [SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN] controls
according to target fish or fishing area.
5. Press the CUSTOM MODE keys [1], [2] or [3] to program. You are asked if you want to save
the settings to the custom key pressed. (In the example, the custom key [1] was pressed.)
: CHANGE MENU: END
SAVE THE SETTING TO CUSTOM1 KEY?
NO YES
6. Press to select YES.
7. Press the [MENU] key. The message “PRGM SET” appears at the screen top.
8. Press the [MENU] key to finish.
Activating custom mode
1. Press appropriate CUSTOM MODE key. The indication CUSTOM1, CUSTOM2 or
CUSTOM3 appears at the top of the screen depending on key pressed.
2. To escape from the custom mode operation, operate any of the controls among [MODE],
[SECTOR], [TRAIN], [RANGE], [TILT] and [FAST SCAN].