FUJITSU SPARC ENTERPRISE M3000 - Manual (Page 206)

E-6 SPARC Enterprise M3000 Server Service Manual • November 2009
E.4 Using the showhardconf Command
This section describes the showhardconf command on the DC power supply
model.
Note – This is equivalent to Section 3.5.1, “Using the showhardconf Command” on
page 3-11 , Section 4.4.1, “FRU Removal and Replacement” on page 4-8 and
Section 4.5.4, “Verifying the Hardware Operation” on page 4-15 . When using the DC
power supply model, refer to the content described in this appendix.
On the DC power supply model, the showhardconf command output for the CPU
and the power supply unit section is as shown in the example below.
For details, see the showhardconf command man pages.
+ CPU Status:Normal;
+ Freq:2.750 GHz; Type:32;
+ Core:4; Strand:2;
.
.
PSU#0 Status:Normal; Serial:EA09320015;
+ FRU-Part-Number:CA01022-0730 01A /300-2278-01 ;
+ Power_Status:Off;
+ Type:DC;
PSU#1 Status:Normal; Serial:EA09320016;
+ FRU-Part-Number:CA01022-0730 01A /300-2278-01 ;
+ Power_Status:Off;
+ Type:DC;