Native Instruments MASCHINE MK3 Groove Production Studio (Black) User Manual
Page 29
MASCHINE setup with a line level device (here a synthesizer) as input.
To use the MASCHINE controller in a setup with typical line level equipment:
1.
Turn the
LINE OUT VOLUME
and
PHONES VOLUME
knobs on the rear panel of the MA-
SCHINE controller to the left-end stop to set the output and headphones volumes to mini-
mum.
2.
Plug a pair of 1/4" TRS jacks from the outputs of your device into the
LINE IN 1
and
2
sockets on the rear panel of the MASCHINE controller (use a single jack plugged into the
LINE IN 1
socket if you are using a mono device).
3.
Adjust the output signal of your connected device by using its relevant volume/gain con-
trol. Check that your input signal does not clip.
4.
Turn the
LINE OUT VOLUME
and
PHONES VOLUME
knobs back to their usual levels.
Setting Up MASCHINE
Setup Examples
MASCHINE - Getting Started - 29