Native Instruments MASCHINE MK3 Groove Production Studio (Black) - Manual (Page 114)

1. Press CHANNEL or PLUG-IN depending on whether the parameter is located in Channel
properties or in a Plug-in, respectively.
2. Select the channel (Sound, Group or Master) containing the parameter:
If the parameter is at the Master level, press Button 1 ( MASTER ).
If the parameter is in a Group, press Button 2 ( GROUP ) and select that Group by pressing
its Group button A – H .
If the parameter is in a Sound, press Button 3 ( SOUND ), select its parent Group by press-
ing its Group button A – H , and select that Sound by pressing its pad (with pads in Group
mode, PAD MODE lit) or SELECT + its pad (this works with pads in any mode).
3. Now move the 4-D encoder to the left or to the right to select the particular Plug-in or the
particular Channel properties in which the parameter is located.
4. If parameters are spread over several pages, use the Page buttons (the two arrow buttons
left of the displays) to show the page containing the desired parameter.
→ Now the parameter appears in the displays and you can adjust it via one of the Knobs 1–8
underneath.
Navigating to the desired parameter.
Modulate the Parameter
To modulate one or more parameter(s) visible in the displays:
1.
Press PLAY to start the sequencer.
2. Hold AUTO and turn Knob 1–8 under the displays corresponding to the parameter(s) that
you want to modulate.
Applying Effects
Modulating Effect Parameters
MASCHINE - Getting Started - 114