Native Instruments MASCHINE MK3 Groove Production Studio (Black) - Manual (Page 147)

→ The start and end Sections along with all Sections in-between are played one after the
other in a loop. The Arranger timeline indicates the new loop range.
The loop range now contains three Sections.
You will note that selecting a single Section amounts to selecting a one-Section-long loop range.
10.3.2 Selecting a Loop Range using the Controller
On your controller:
1.
Press SHIFT + SCENE ( Section ) to access the Arranger view (if you are not already in the
Arranger view).
2. Press and hold SHIFT + SCENE ( Section ) to enter Section mode (or pin it by pressing
SHIFT + SCENE ( Section ) + Button 1).
3. Press and hold the pad corresponding to the start Section.
4. While holding the first pad, press the pad corresponding to the end Section.
The start and end Sections along with all Sections in-between are played one after the other in
a loop.
10.4 Saving Your Project
Again, it is recommended to regularly save your work. You can then open another Project or
close MASCHINE and take a break. Your tutorial Project will be recalled as it was the next time
you open it.
To save your Project in the software:
Creating an Arrangement
Selecting a Loop Range
MASCHINE - Getting Started - 147