AJA KONA 4 PCI-E Video I/O Card (HDMI Output, Cable Included) - Manual (Page 66)

KONA Capture, Display, Convert v15.5 66 www.aja.com
Video Setup Screen in 4K Mode
Figure 35. AJA Control Panel, Video Setup Screen
4K Mode adds Quad Swap controls to the Video Setup Screen.
SDI Input Quad Swap
• When checked (default setting is Off), changes the input Quad to SDI
quadrant mapping from 1 to 1 to:
• Quad1 - SDI3
• Quad2 - SDI4
• Quad3 - SDI1
• Quad4 - SDI2
SDI Output Quad Swap
• When checked (default setting is Off), changes the output Quad to SDI
quadrant mapping from 1 to 1 to the mapping shown above.
Automatic KONA 4-Link to 2-Link Switching
You can use Quad Swap settings to automatically switch KONA 4K operation
from 4-Link to 2-Link transport, without the need to repatch KONA BNCs for each
transport change. This can be useful if, for example, you want to connect KONA's
outputs to an SDI monitor that sometimes views 4-Link 4K/UltraHD inputs, and
sometimes views 2-Link or Single-Link HD inputs. All that is required is to re-
orient KONA's output BNC connectors once, and turn on SDI Output Quad Swap.