AJA KONA 4 PCI-E Video I/O Card (HDMI Output, Cable Included) - Manual (Page 43)

KONA Capture, Display, Convert v15.5 43 www.aja.com
SDI 2
Same parameters as SDI Output 1, but are applied to the KONA card SDI Output 2
(SDI output BNC 4).
HDMI Screen
The HDMI screen is used to configure the KONA card's HDMI Output signal.
HDMI Output
Source
• Auto - Automatically sets the HDMI output format, based on the input or
selected format.
• Primary - Selects the framebuffer format for output.
• Secondary (KONA 4 in UFC mode) - Sets the HDMI output to the Converted
Format (set in the Format screen) for up/down/cross-conversion).
• 4K Quarter (KONA 5, KONA 4 in 4K mode) - Sets the HDMI output to
downconvert to HD.
NOTE: The 4K Transport setting on the SDI Out screen also affects the KONA HDMI
output signal, even if the SDI inputs are not being used. A SMPTE 2Si setting
is required for UltraHD/4K HDMI output. Other 4K Transport settings will
downconvert HDMI output to HD or 2K.
Audio Ch
This pulldown allows you to select the number of embedded audio channels for
the HDMI output. Two or eight channels can be chosen. Select from:
• 2 Ch 1-2 through 15-16
• 8 Ch 1-8
• 8 Ch 9-16