beautypg.com

Sdi 1 – AJA KONA 4 PCI-E Video I/O Card (HDMI Output, Cable Included) User Manual

Page 42

background image

KONA Capture, Display, Convert v15.5 42 www.aja.com

• 2xHD-DL: Dual link HD output using two BNCs. The Level B-DL format is the

mapping of dual-link HD-SDI/SMPTE 372M (i.e.: 1080p up to 60 fps) in a single

serial digital interface at the nominal 3 Gbit/s.

• 3Gb - Single link HD output using one BNC. The Level B-DS format is the dual-

stream carriage of two independent HD-SDI/SMPTE 292M signals (720p up

to 60 fps or 1080i/1080p up to 30 fps) in a single serial digital interface at the

nominal 3 Gbit/s.

• 3Ga - Single link HD output using one BNC. The Level A format is the direct

mapping of uncompressed 1080p (up to 60 fps) video into a serial digital

interface at the nominal 3 Gbit/s.

NOTE: See

"SDI Output Screen in 4K Mode" on page 65

and

"SDI Output Screen in 8K

Mode" on page 74

for information about higher capacity transports.

Figure 27. SDI Output Screen, KONA 4 in UFC Mode

On KONA 4 in UFC Mode, two SDI output are available (SDI 1 and SDI 2) which can

be configured differently from each other. For example, one output can be the

Device format and the other output can be the Converted format.

SDI 1

Sets the output format for SDI 1 (SDI output BNC 3). Parameters are the same as

"Output Options" on page 41

, except you can select a Converted Format and 4K

Transport settings are not available:

Select

Same as above with the addition of a Secondary output format:

• Secondary - When selected, this indicates that the SDI output is set to a format

different from the framebuffer (Device Format). That Converted Format value

will be listed in green. This shows that active processing of the video is taking

place (format change and possibly up- or down-conversion).