ARRI ALEXA Mini LF Ready to Shoot V-Mount Set (LPL) - Manual (Page 88)

Monitoring 88
If both SDI 1 and 2 are supposed to show processed images, SDI 2 needs to be configured as SDI 1
clone.
SDI 2 Clone
You can set SDI 2 as a clone of SDI 1. SDI 2 will inherit all settings from SDI 1. The configuration
options for SDI 2 are grayed out while it is configured as a clone of SDI 1. If you change a value for SDI
1, the same value becomes active for SDI 2 as well.
► Select
MENU > Monitoring > SDI > SDI 2: Clone SDI 1 .
18.9 EVF/Monitor Settings
► Select MENU > Monitoring > EVF/Monitor > Settings .
Following options are available:
EVF Brightness Brightness of the EVF is adjustable with values 120, 200 and 300 (Nits).
The default value is 120.
EVF Power
Auto EVF OLED display is activated and deactivated automati-
cally, depending on the MVF proximity sensor state. This
is the default setting.
Off Deactivates the EVF OLED display permanently so that
it remains switched off even when the proximity sensor is
covered e.g. by a rain cover.
On Use this setting to override the MVF-2 proximity sensor
and to constantly enable the viewfinder display. This set-
ting should be regarded as an emergency setting to be
used, for example, when the proximity sensor is faulty and
no longer activates the viewfinder display anymore.
NOTICE
Please be aware that when enabled, and used for
prolonged periods, this configuration may cause irre-
versible burn-ins on the EVF OLED. With the setting en-
abled, the camera will issue a corresponding warning
after each boot-up and sensor mode switch.
EVF Eyepiece Heating The MVF-2 is equipped with a built-in eyepiece heater to prevent fog-
ging of the eyepiece when shooting in cold environments. The eyepiece
heater only becomes active when the eyepiece has a temperature of 15°
C / 59° F or below. In really cold environments please use the Heated
Eyecup HE-7.
EVF Image Rotation
180°
When mounting the MVF-2 on the right side of the camera, the viewfind-
er image can be rotated by 180° for correct orientation of the image in
the viewfinder. This setting only affects the viewfinder image, the SDI
outputs are not rotated.
Monitor Brightness Adjusts the brightness of the MVF flip-out monitor from 1 (minimum) to
10 (maximum). The default value is 06.