ARRI ALEXA Mini LF Ready to Shoot V-Mount Set (LPL) - Manual (Page 114)

Electronic Control System (ECS) 114
Note: Make sure that each camera on set uses its own white radio channel.
Note: It is not supported that one hand unit connects to two cameras in parallel.
Note: When using white radio and WiFi simultaneously it is important to configure the used
channels to avoid interference and guarantee optimal performance. See the channel configuration
table in the WiFi chapter "WiFi Host Channel" for more information.
Wireless Region Setting
The wireless region setting specifies the region the white radio can be used in compliance with local
regulations.
1. Select
MENU > Electronic Control System (ECS) > Radio > Wireless Region Setting .
The following options are available:
Australia
Canada
China
Egypt
Europe
Hong Kong India
Israel
Japan
New Zealand
Philippines
Singapore South Africa
South Korea
Taiwan
Thailand
UAE
USA
World
2. Set the region the white radio is used in.
NOTICE
Please ensure that the region is configured correctly, as it may be illegal to use white radio in a
region other than specified in the setting. All settings are compliant to FCC and IC regulations.
Connect a Hand Unit to the Camera
► Make sure camera and hand unit are set to use the same white radio channel and wireless region.
The hand unit connects automatically to the camera.
25.2 Lens Motors
The ALEXA Mini LF supports the use of cforce mini and cforce plus lens motors. Lens motors are
connected to the LBUS connector of the lens mount and can be daisy chained. The motors can be hot
plugged, no need to switch off the camera.
When connecting a cforce plus motor to the camera please make
sure that the LBUS connector(s) on both motor and lens mount
are equipped with a silver washer placed below the red nut (2) of
the connector.
If the LBUS connectors on either cforce plus motor or lens mount
(or both) miss the silver washer (1), the cforce plus motor needs
to be supplied with external power (e.g. D-Tap from a battery
adapter plate) in order to ensure proper performance.
Note: cforce mini motors are not affected and can always be
powered through the lens mount.
1 2
Motor Calibration
After connecting a lens motor to the camera it must be calibrated.