beautypg.com

10 power supply, Power supply – ARRI ALEXA Mini LF Ready to Shoot V-Mount Set (LPL) User Manual

Page 26

background image

Power Supply

26

10 Power Supply

BAT IN

The ALEXA Mini LF accepts an input voltage range from 11.0 to 34.0 V DC.

The camera can be solely powered through the 8-pin LEMO BAT connec-

tor located at the back of the camera. You can use the KC50-S (K2.75007.0)

or KC50-SP-S (K2.0001275) power cable or one of the various on-board

adapter plates for V-Mount and Gold Mount batteries to supply the camera

with power.

NOTICE

Power solutions from ARRI (K2.0014530, K2.0014531, K2.0014532, K2.0014533) can be used

safely up to a total current of 10 A (e.g. 144 W total at 14.4 V, including camera and powered

accessories). For use cases demanding more than 10 A, alternative solutions such as block

batteries or the B-Mount Power Splitting Box should be considered.

Accessory Power

24 V

The total available power on the 24V ACC converter is just below 100 W to be compliant with DIN EN

62368 PS2 (limited power source annex Q, table Q.1, single fault tolerant). The camera's 24V ACC

converter power is shared by

RS Connector
EXT Connector
LBUS Connector (on lens mount)
ETH Connector

Typically, the 24V ACC converter delivers a permanent current of 3.0 A at 14.0 V camera supply

voltage and ambient temperatures of 25° Celsius / 77° Fahrenheit.
If the camera supply voltage is low, typically below 14.0 V (the camera is designed for Li-Ion based

batteries that deliver about 14V until discharged to about 10-15%) the boost converter is current limited

and the power on the 24V ACC converter is limited furthermore. Reason here is, that maximum current

draw from the entire camera should not exceed 20A under all conditions since no on-board batteries

can deliver higher currents.

12 V

The 12V ACC converter power is shared by

12V Connector
AUDIO Connector

and outputs 12 V with a max. current of 2 A. If the camera supply voltage is below 13.5 V, the 12 V

ACC converter power output is reduced by approx. 1,5 V.

Power Consumption

In order to process the increased pixel count while still maintaining ALEXA image quality, the ALEXA

Mini LF draws between 69 W and 89 W while recording, with MVF-2 connected, but no further

accessories attached. 69 W have been measured while recording MXF/ARRIRAW in recording

resolution LF 16:9 UHD at 24 fps. 89 W have been measured while recording MXF/Apple ProRes in

recording resolution LF 16:9 2K at 90 fps. Electronic accessories will increase power draw based on the

accessories’ draw.

This manual is related to the following products: