Panasonic DMR-T3040 - Manual (Page 41)

The program is erased.
Press [◄] to
select “Erase” and
press [ENTER].
'The disc’s available recording time may not increase after
erasing short programs.
I Computer data cannot be erased.
'The available recording time on DVD-R does not increase when
you erase programs.
• Cancel Disc Protection {-» page 38) or Cartridge Protection page 8) it
they are currently set.
• The full title is shown in the Properties screen, but if you enter a long title,
only part of it is shown in the program list.
• If you enter a long title, only part of it is shown in the menu screen after
finalization. hm » b : i
Press [◄] to set (or
cancel) protection
and press [ENTER].
The lock symbol
appears when the
program is write-
protected.
■
O)
c
Press [ENTER] at
the start point of
the section you
want to erase.
CE®
i End 1
Press [ENTER] at
the end point of the
section you want to
erase.
1
! Niïn
MES*
i-vii siiirt 1
inPBTti! '
£nd
S
Press [A, T] to select “Next” and press [ENTER], then press [◄] to
select “Erase” and press [ENTER].
Repeat to enter other sections.
• Use search and slow-motion to find the start and end points.
• Play pauses if the end of the program is reached during this procedure.
• You may not be able to specify points within 3 seconds of each other.
• You cannot specify an end point before a start point, or a start point after an end
point.
• You cannot specify points on still pictures in the program.
• The disc’s available recording time may not increase after erasing short segments.
Press [◄] to
select “Erase”
and press
[ENTER].
Press [ENTER] at the'
point you want to
divide the program.
To change the division point
below
Press [A, ▼] to
select “Exit”
and press
[ENTER].
Bi»l ja PWMfam
Unta ynu dindi Sit dugnni,
n will ait he raslDrad u Sta arlgliiil.
I'" Iftfhie'.......... 1 j ~ ¿¡nell I
The program is divided.
c
Press [◄] to select
“Divide” and press
[ENTER].
To confirm the division point
Press [A, V] to select “Preview” and press [ENTER].
(Play will begin from a point 10 seconds prior to and
after the division point.)
To change the division point
Press [A, ▼] to select “Divide” and press [ENTER]
at the point you want to change.
• The divided programs retain the title of the original program. They also retain
the CPRM property (-» page 65) of the original.
• A minute portion of the recording directly preceding the division point may be lost.
• It is not possible to carry out Divide Program in the following cases:
-when the program is extremely short.
- when the total number of programs is more than 250 (HDD) or 99 (DVD-RAM).
RQT6637