Baseline Systems BaseStation 1000 - Manual (Page 75)

BaseStation 1000 Irrigation Controller Manual
4. Notice that the minutes placeholder in the Runtime field is highlighted.
 To move to the seconds placeholder,
press the  button.
 To move to the hour placeholder,
press the  button.
 To change the time, press the + or –
button.
Note: To rapidly increase or decrease
the value, press and hold the + button or the – button.
5. Press the  button to highlight the number in the Max Concurrent field, and then press the +
or – button to change the number to indicate the maximum number of zones that can run at
the same time during this manual run.
6. If you want to delay the start of the manual run, press the  button to highlight Start Delay.
Notice that the minutes placeholder is highlighted.
 To move to the hour placeholder, press the  button.
 To move to the seconds placeholder, press the  button.
 To change the time, press the + or – button.
Note: To rapidly increase or decrease the value, press and hold the + button or the –
button.
7. If you want a delay between the zones of the manual run, press the  button to highlight
Zone Delay. Notice that the minutes placeholder is highlighted.
Note: If the Max Concurrent field is set to more than 1, the Zone Delay field does not display.
 To move to the hour placeholder, press the  button.
 To move to the seconds placeholder, press the  button.
 To change the time, press the + or – button.
Note: To rapidly increase or decrease the value, press and hold the + button or the –
button.
8. Press the OK button. The Manual Run screen displays the elapsed time for the currently
running zone.
9. When the manual run is complete, the Run screen displays “No Running Zones.” Choose one
of the following options:
 If you want to return to the Manual Run menu, press the Manual Run button.
 If you want to display the Zone Status, press the BACK button. Press the  or  button
to highlight Zone Status, and then press the OK button.
Page 69