Baseline Systems BaseStation 1000 - Manual (Page 100)

BaseStation 1000 Irrigation Controller Manual
To display a message when a program stops
1. Press the Program Setup button. The Program Setup menu displays.
2. If the program that you want to enable the message for displays in the upper-left corner of
the screen, continue to step 3. Otherwise, press the PRG button until the program that you
want to enable the message for displays in the upper-left corner of the screen.
Note: To move backwards in the list of programs, press and hold the PRG button, and then
press the – button repeatedly.
3. Press the  button to highlight the Setup Prg. Stop option, and then press the OK button. The
Setup Prg. Stop screen displays.
Note: For information about configuring the fields on the Setup Prg. Stop screen, refer to
Setting a Stop Condition for a Program on
page 52.
4. Press the  button to highlight the Display
Message option, and then press the + button
to display a checkmark in the field.
5. To view the message, perform the steps in
Viewing Operator Messages on page 92.
Viewing Moisture Graphs
1. Press the RUN button.
2. Press the BACK button. The Status Report menu displays.
3. Press the  or  button to highlight View Graphs, and then press the OK button. The
moisture graph for sensor 1 displays. The date range displays on the horizontal axis of the
graph and the moisture percentage displays on the vertical axis.
4. Perform either of the following actions:
 To display the graph for a different soil moisture sensor, press the  or  button.
 To change the date range, press the + or – button.
Page 94