Baseline Systems BaseStation 1000 - Manual (Page 115)

BaseStation 1000 Irrigation Controller Manual
Configuring a Booster Pump
If you have multiple programs that use the same water source, and one or more of those programs
require a booster pump, you need to associate the booster pump with the program rather than
with the water source.
1. Set up any flow sensors or master valves in the Water Source Setup. Refer to Assigning a Flow
Sensor to a Water Source on page 58 and Assigning a master Valve/Pump Start biCoder to a
Water Source on page 59.
2. Associate the booster pump with the program. Refer to Setting Up a Master Valve/Pump Start
for a Program on page 55.
Page 109