Hawk Industries Hawkjaw Jr. Manual 65K-2GJR Serial Numbers 10 to 20 - Manual (Page 58)

Changing the Grip Cylinders
7. Remove the 3 bolts (B) that
mount the grip cylinder Clevis
Plate (CP). Then remove the
Hook Clevis Plate (CP).
10. Pull out the Middle Grip
Cylinder Cap side Pin (MCP).
11. Slide out the Middle Grip Cylin-
der (MC).
12. Use the Two 11/16" wrenches to
slowly loosen the Rod side Hose
(RH). Check for fluid flow.
Bleed any pressure. Disconnect
the Rod side Hose (RH).
13. Use the Two 11/16" wrenches to
slowly loosen the Cap side Hose
(CH). Check for fluid flow.
Bleed any pressure. Disconnect
the Cap side Hose (CH).
14. Replace the Middle Grip
Cylinder (MC).
15. Use the Two 11/16" wrenches to
connect the Cap side Hose (CH).
16. Use the Two 11/16" wrenches to
connect the Rod side Hose (RH).
17. With the Middle Grip Cylinder in
place, replace the Clevis Plate
(CP). Be sure the rod on the
Hook Clevis Plate assembly goes
through the eye on the cylinder
rod.
18. Replace the 3 bolts (B) in the
Hook Clevis Plate (CP).
20. Insert the Middle Grip Cylinder
Cap side Pin (MCP).
B
RH
CH
MCP
MC
58 Maintenance & Repair
Continued on next page.
CP