Hawk Industries Hawkjaw Jr. Manual 65K-2GJR Serial Numbers 10 to 20 - Manual (Page 29)

Break Out
1. Follow the steps on pages 14, 24-
30.
2. Rotate the Selector Switch (SS)
clockwise to the break position.
3. Push in the Grip Hold (GH)
button.
4. Push and hold in the wrench Grip
(G).
5. Push and hold down Torque (T).
6. When break out occurs, release
Torque (T). Immediately release
the wrench Grip (G). See note
below.
7. Press and hold down Spin (S)
until the stand pops out of the
connection. Release Spin (S). If
the stand will not spin, release
Spin (S). Repeat Steps 4-6.
8. Pull out the Grip Hold (GH)
button.
9. You are now able to remove the
Hawkjaw from the pipe.
S T
29 Operation
G
Operation
GH SS
Warning
When Hawkjaw is at rest, press in the
red E-Stop (E) button.
E
Note:
If connection will not break, increase
torque adjustment (TA) as necessary.
.