Hawk Industries Hawkjaw Jr. Manual 65K-2GJR Serial Numbers 10 to 20 - Manual (Page 40)

Spinner Maintenance
40 Maintenance & Repair
1. Pull the Hawkjaw onto the pipe.
2. Press in the Grip Hold (GH)
button.
3. Press and hold the Spin (S)
button. While holding down the
Spin (S) button, press and hold
the Chain Oiler (CO) button for 3
seconds.
4. Release the Spin (S) button.
5. Pull out the Grip Hold (GH)
button.
Chain Lubrication
1. Position the Hawkjaw for
breakout.
Initial Steps
Notice
Spinner chain lubrication must be
done during normal operation of the
Hawkjaw. Do not run the spinner
when the Hawkjaw is not on the pipe.
GH
CO
Chain oiler nozzle
NOTE: Clean nozzle screen as required
S
CAUTION:
This chain oiling system uses
minimal amount of hydraulic oil
from power unit - we suggest
you monitor hydraulic oil level
accordingly.