4.3 enabling eserver access control, Configure eserver connection security, Enable eserver access control – Innotech eServer User Manual
Page 87: E 4-18, E 4-19
Page 87
eServer Setup and Site Installation Instructions
© Mass Electronics Pty Ltd 2009
Chapter 4 – Configuring eServer Communications
4-4.3 Enabling eServer Access Control
If you want
Access Control on your project, go to Access Control. Tick the Enable access control
for this project box, and enter the information, as illustrated below in Figure 4-19. If you don’t want
Access Control, leave it blank.
Figure 4-18: Configure eServer Connection Security
From the Preferences Menu, tick the
Enable security for connection to eServer box and enter the
required Username and Password, as illustrated below in Figure 4-18 (if you don’t want extra eServer
Connection security, leave it blank).
NOTE
If your Magellan Project has access control setup already, simply check the box and this information will be added
automatically.
Figure 4-19: Enable eServer Access Control