A-2.2 updating eserver / magellan project settings, Open icomm server properties – Innotech eServer User Manual
Page 107

Page 107
eServer Setup and Site Installation Instructions
© Mass Electronics Pty Ltd 2009
Chapter A – eServer Upgrade Guide
A-2.2 Updating eServer / Magellan Project Settings
A new feature in eServer v1.20 or greater is the ability to support both an Internal AND External DNS
names or Static IP addresses. This simplifies the connection process where a site may require both
internal and external connection to the eServer BMS System.
Open your eServer Project using
Magellan Builder v1.20 or greater. From the Point Manager
window, select your iComm Server and open
Properties... as illustrated below in Figure A-1.
Figure A-1: Open iComm Server Properties