Innotech eServer - Manual (Page 80)

eServer Setup and Site Installation Instructions
Page 80 © Mass Electronics Pty Ltd 2009 Edition 5.0 dated 07/01/2014
4-2.5 Set iComm Connection Properties
In the Magellan Project, navigate to the Points Manager and check all connection settings. Open the
Properties of the site iComm Server, as illustrated below in Figure 4-9.
Figure 4-9: Point Properties
You may need to create a new iComm Server if none are visible in the project. From the drop down menu illustrated
below in Figure 4-9, select New IO Server.
NOTE