Inter-Tel CS-5400 User Manual
Page 58
Administrator Procedures
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page 40
Trunk Programming
SION OPTION, press
or the
POLARITY REVERSE
menu button for the polar-
ity-reversal supervision type. Or, press
or the
VALID CALL
menu button for
Valid Call timer supervision. Or, press
or the
VALID + POLARITY
menu button
for Valid Call timer with Polarity Reversal supervision. Then press
or
ACCEPT
to continue.
Caller ID: To enable or disable Caller ID, press
or the
CALLER ID
menu but-
ton. When the display shows SET CALLER ID, press
or
ON
to enable the fea-
ture, or press
or OFF to disable it. Then press
or
ACCEPT
to continue.
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the
HYBRID BALANCE
menu button. When the display shows HYBRID BAL-
ANCE OPTION, press
or the
NORMAL
menu button, or press
or the
SHORT
menu button. Then press
or
ACCEPT
to continue.
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press
or
the
SIGNALING
menu button. When the display shows ENTER SIG-
NALING OPTION, press
or the
DTMF
menu button, or press
or the
PULSE
menu button. Then press
or
ACCEPT
to continue.
Trunk Group Number: To assign the trunk to a trunk group, press
or the
TRUNK
GROUP
menu button. When the display shows ENTER TRUNK GRP EXTEN-
SION, enter the desired trunk group number using one of the methods described on
Busy Trunk: To temporarily remove the trunk from service, press
or the
BUSY
TRUNK
menu button. When the display shows MARK TRUNK BUSY, press
or the
ON
menu button, or press
or the OFF menu button. Then press
or
ACCEPT
to continue.
c.
To exit, press
or
ACCEPT
to move backward through the prompts until you
reach the ENTER DATABASE OPTION prompt.
5.
To Program A Trunk Group: Press
or the TRUNK GROUP menu button. Then
program the trunk group, as follows:
a.
The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on
b.
The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Access For Day Or Night Mode: To program the endpoint(s) that will
have answer access for this trunk group for day mode, press
or the
ANS-
ACCESS DAY
menu button. To program for night mode, press
or the
ANS-
ACCESS NIGHT
menu button. When the display shows ENTER ENDPOINT
EXTENSION, perform the procedure described on the following page.
1.) Enter a endpoint extension using one of the methods described on
2.) The display shows the extension number and a Yes/No prompt. To include the
endpoint in the list, press
or the YES menu button, followed by
. Or, to
exclude the endpoint from the list, press
or the NO menu button, followed
by .
3.) When the display returns to ENTER ENDPOINT EXTENSION, select
another extension number. Or, if finished programming the endpoint list, press
or ACCEPT to continue.
1
2
3
#
2
1
2
#
3
1
2
#
4
1
2
#
5
6
1
2
#
#
2
1
2
1
#
2
#
#