HP E1459A - Manual (Page 55)

54 HP E1459A SCPI Command Reference
[SENSe:]EVENt:PORT n:EDGE?
Returns the status of the Edge Detect Event for Port n as either a a (unsigned) 0 or a 1.
Parameters
Comments •
A 0 means an edge event was not detected; a 1 means an edge event was
detected.
•
An edge event must have been enabled by the
[SENSe:]EVENt:PORTn:EDGE<state> command and a Positive edge mask
and/or Negative edge mask must be enabled and set to a non-zero value.
•
The Edge Event Status is cleared by reading PEDGE and/or NEDGE status
registers for that port.
[SENSe:]EVENt:PORT n:EDGE:ENABle
Enables / disables an edge event interrupt for Port n.
Parameters
Comments •
Refer to the [SENSe:]EVENt:PORTn:PEDGe:ENAB or
[SENSe:]EVENt:PORTn:NEDGe:ENAB commands to configure the edge
detect registers.
•
The Edge Event Status is cleared by reading PEDGE and/or NEDGE status
registers for that port.
•
*RST Condition: not enabled.
Example EVEN:PORT 2:EDGE:ENAB ON Enables Edge Detection on Port 2
Parameter Name Parameter Type Range of Values Default
PORT n numeric 0, 1, 2, 3 (PORT = PORT0) PORT0
Parameter Name Parameter Type Range of Values Default
PORT n numeric
numeric or discrete
0, 1, 2, 3 (PORT = PORT0)
0, 1, OFF, ON
PORT0
OFF
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com