HP E1459A - Manual (Page 53)

52 HP E1459A SCPI Command Reference
SENSe Subsystem
The SENSe Subsystem configures Event Detection in the HP E1459A Module. The
HP E1459A has an event detector for each 16 bit Port to detect positive or negative
edge transitions and whether new data is available:
DAV New data is available on the specified digital input port(s).
NEDGe Negative Edge transition occurred on a specified digital input
channel(s).
PEDGe Positive Edge transition occurred on a specified digital input
channel(s).
For details on using the SENSe Subsystem, refer to Chapter 2.
Syntax [SENSe:]EVENt
:PORT n:DAVailable? page 52
:PORT n:DAVailable:ENABle page 53
:PORT n:DAVailable:ENABle? page 53
:PORT n:EDGE? page 54
:PORT n:EDGE:ENABle page 54
:PORT:EDGE:ENABle? page 55
:PORT n:NEDG? page 55
:PORT n:NEDG:ENABle page 56
:PORT n:NEDG:ENABle? page 56
:PORT n:PEDG? page 57
:PORT n:PEDG:ENABle page 57
:PORT n:PEDG:ENABle? page 58
:PSUMmary:DAVailable? page 58
:PSUMmary:EDGE? page 59
[SENSe:]EVENt:PORT n:DAVailable?
Returns the status of the DAVailable Event for Port n as either a (unsigned) 0 or a 1.
Parameters
Comments •
1 indicates the event did occur; 0 indicates the event did not occur.
•
The event must be enabled using the [SENS:]EVEN:PORTn:DAV:ENAB
command.
•
The event is cleared by reading the data on Port n with the
MEAS:DIG:DATAn? command.
Example SENS:EVEN:PORT 2:DAV? Returns status of DAV Event for Port 2
EVEN:PORT 1:DAV? Returns statusof DAV Event for Port 1
Parameter Name Parameter Type Range of Values Default
PORT n numeric 0, 1, 2, 3 (PORT = PORT0) PORT0
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com