HP DL365 - Manual (Page 35)

Removal and replacement procedures 35
NOTE: Access to the ejector button is intentionally restricted. To eject the optical device, push
the ejector button with a small flat object such as a key or pen.
2. Eject the device or blank.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To replace the component, reverse the removal procedure.
Multibay backplane assembly
To remove the component:
1. Power down the server (on page 25 ).
2. Extend or remove the server from the rack (" Extend the server from the rack " on page 25 , " Remove
the server from the rack " on page 26 ).
3. Remove the access panel (" Access panel " on page 30 ).
4. Remove the air baffle (" Air baffle " on page 31 ).
5. Remove fan module 3 (" Fan module " on page 31 ).
6. Disconnect the cable from the multibay backplane.
7. Remove any device in the multibay (" Multibay blank or device " on page 34 ).
8. Remove the two T-15 Torx multibay backplane assembly screws.