HP DL365 - Manual (Page 28)

Removal and replacement procedures 28
6. Remove the T-10 Torx screws located on the sides of the bezel.
7. Gently push on the two tabs located at the top of the bezel
8. Rotate the bezel away from the server and remove the bezel.
To replace the component, reverse the removal procedure.
Hard drive bezel blanks
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Remove hard drives 1 and 2 (" Hot-plug SAS or SATA hard drives " on page 27 ).