Install the software for a network connection – HP Photosmart Premium Fax C410 User Manual

Page 16

Connect the other end of the Ethernet cable to an available port on your Ethernet
router, switch, or wireless router.

Once you have connected the product to the network, install the software.

Install the software for a network connection

Use this section to install the HP Photosmart software on a computer connected to a
network. Before you install the software, make sure you have connected the
HP Photosmart to a network. If the HP Photosmart has not been connected to a network,
follow the onscreen instructions during the software installation to connect the product to
the network.

NOTE:

If your computer is configured to connect to a series of network drives, make

sure that your computer is currently connected to these drives before installing the
software. Otherwise, the HP Photosmart software installer might try to use one of the
reserved drive letters and you will not be able to access that network drive on your
computer.

NOTE:

Installation time can range from 20 to 45 minutes depending on your

operating system, the amount of available space, and the processor speed of your
computer.

Chapter 3

Finish setting up the HP Photosmart

Finish

set

ting u

e HP Photo

sma
rt