High End Systems Power Cue DMX - Manual (Page 49)

44
PROGRAMMING A CHASE
Scenes made with moving lights may be programmed together into a sequence called a chase. You
can also make a chase with scenes of generic lighting.
1. Press Program/Edit
2. Press Chase
5. Select attributes for this chase step:
STEP- and STEP+ allow you to move through
the series of scenes you are programming into
the chase, so that you can fine tune the
attributes.
FADE allows you to control the time between
steps and
HOLD is the time that a chase rests
on one step before passing to the next fade time
and the next step.
You may adjust FADE and HOLD for each step
or you may choose to have all FADEs of one
length and all HOLDs of one length. In this
case select
GLOBAL. The global time is set
later after all the chase steps have been
selected.
STOP has three options:
•No effect
•The chase stops at this scene
•The chase loops to the start at this scene.
The DIPLESS crossfade option is not active in
this version and is permanently switched on.
Press STORE.... to confirm the attributes for
the current chase step and loop to step no. 4 to
select the next step and edit its attributes. After
setting the attributes for the last required step,
press ESCAPE.