HP C100/110 - Manual (Page 44)

28
Setting Up Your Printer
This chapter describes how to configure your workstation to use a printer
that you have physically attached to either the parallel connector or the serial
(RS-232C) connector on the rear of your workstation.
This chapter is divided into the following sections:
• Gathering printer information
• Setting up a local printer using SAM
• Setting up your printer for network printing
• Printing a file
• Solving printing problems
The instructions in this chapter assume you are using HP-UX version 9.05 or
10.0 operating system with HP VUE version 3.0 or later interface.
NOTICES: Make sure you have installed the printer as described in the manufacturer’s instruc-
tions before following the instructions in this chapter. Also ensure that the printer is
powered on, connected to your workstation, has paper loaded, and is online.
Some procedures in this chapter require you to log in as root. If you cannot
log in as root, contact your system administrator.