HP C100/110 - Manual (Page 207)

191
The Boot Console Interface
Displaying and Setting the Monitor Type
Trying to change the monitor type on an empty slot, fails and gives you this
warning message:
Configuration Menu: Enter command > monitor graphics4
MONITOR INFORMATION
WARNING: Intended graphics hardware does not exist.
Be sure to install the hardware after you power down the system.
Slot # HPA State Resolution Frequency Class
--------- ------- ---- ---------- --------- -------
graphics3 f4000000 Present Fixed
graphics4 f6000000 Empty
Current Console Path: core.RS232_.9600.8.none
Stable Store Console Path:GRAPHICS3
Table 26 shows the possible combinations of graphics cards and slots.
Graphics 3, and Graphics 4 refer to the console paths, GRAPHICS3, and
GRAPHICS4, respectively. There is no GRAPHICS 1 or GRAPHICS 2
path. Configurations 6 and 7 use the GRAPHICS3 path even though the
Geometry Accelerator card is in slot 4.
The abbreviations in the table represent the following:
"S”, a color graphics or Hyperdrive series graphics card
"D”, a dual color graphics card
"V”, a VISUALIZE-48 graphics card