HP C100/110 - Manual (Page 155)

139
Changing Your Workstation’s Hardware Configuration
Removing the Main Tray Assembly
Removing the Main Tray Assembly
Perform the following steps to remove the Main Tray Assembly:
1 Power off the system, the monitor, and any peripheral devices. Unplug the system
unit power cord and the power cord of any peripheral devices from ac wall out-
lets. Disconnect the power cord from the system unit.
NOTICE: There is no need to manually shut down the HP-UX operating system on
your workstation before powering it off. When you turn off the power
switch, your workstation automatically shuts down the operating system
before terminating the power.
2 Disconnect cables from any peripheral devices.
3 Attach a static-grounding wrist strap to bare metal on the back panel of the system
unit.
4 Completely loosen the four captive screws on the rear of the system unit, as
shown in Figure 35.
Figure 35 Removing Main Tray Assembly
Captive Screws
Captive
Screws