HP C100/110 - Manual (Page 133)

117
Changing Your Workstation’s Hardware Configuration
Preparing Your Workstation
Preparing Your Workstation
This section describes how to prepare your workstation for changing its con-
figuration. Use the following procedure to prepare your workstation:
1 Power off your workstation by pressing the power button on the front panel.
When you press the power button, the workstation automatically shuts down the
operating system before it powers off the system.
2 When the workstation has completed shutting down and powering off, power off
the monitor, and any peripheral devices connected to the workstation.
3 Unplug the power cord of the system unit, the monitor, and any peripheral devic-
es from ac wall outlets.
4 Unplug the power cord from the back of the system unit.
5 Remove the floor stand from the system unit, as shown in Figure 20.