HP C100/110 User Manual
Page 187
171
SCSI Connections
Assigning SCSI Device IDs
5
Write in the SCSI device ID of any internal drives in Table 22.
6
Write in the type of external single-ended drives currently connected to your
workstation under the heading “External Device Drives” and each drive’s SCSI
device ID under the heading “Device ID.”
7
Add your new drive to the table if it is an external device. If it is an internal drive,
continue to Step 8.
NOTICE:
The C1700A Magneto-Optical Autochanger uses three SCSI IDs, and
accounts for three of the seven devices allowed on the SCSI bus
Table 22
Single-Ended SCSI Device IDs
SCSI Device Drives
Device ID (Address) Number
(Only 0 through 6 Available)
Internal External
Internal System Drives:
System SCSI Drive(s)
CD-ROM Drive (if present, uses ID No.2)
__________ N/A
4-mm DDS Tape Drive
(if present, uses ID No.1)
__________ N/A
External Device Drives
N/A __________
1st External Device __________________
N/A __________
2nd External Device __________________
N/A __________
3rd External Device __________________
N/A __________
4th External Device __________________
N/A __________
5th External Device __________________
N/A __________
6th External Device __________________
N/A __________
7th External Device __________________
N/A __________
NOTICE: You can have no more than 7 single-ended SCSI devices (internal and ex-
ternal) connected to the system.