HP C100/110 - Manual (Page 165)

149
Changing Your Workstation’s Hardware Configuration
Installing an EISA or GSC Option Board
Installing the Option Board
Follow these steps to install an EISA or GSC board into your workstation:
NOTICE: You may not install any graphics cards in Slots 1 or 2.
1 Remove the main tray assembly as described in “Removing the Main Tray As-
sembly” earlier in this appendix.
2 Press the fan release clip and rotate the fan, as shown in Figure 41.
Figure 40 Rotating the Fan
3 Remove the screw from the EISA retainer, and remove the EISA retainer, as
shown in Figure 41.
Figure 41 Removing the EISA Retainer
EISA Retainer