HP C100/110 - Manual (Page 39)

23
System Overview
Important Information You Need to Note
SCSI ID and Device File Information for HP-UX 9.05
Default device file names for your drives are listed below. The underlined
number in the device file name indicates the SCSI ID number:
Device Device File Name
CD-ROM drive /dev/dsk/c201d2s0
DDS-format tape drive /dev/rmt/3m
These device file names assume the SCSI ID of your drive is set to the fac-
tory default. If you change the factory-set value, you must create a new
device file and substitute the pathname of your device file for the pathname
above. See the System Administration Tasks manual for information on how
to create a device file.
SCSI ID and Device File Information for HP-UX 10.0
Default device file names for your drives are listed below.
Device Device File Name
CD-ROM drive /dev/[r]dsk/c#t#d#
c# identifies the bus address of the SCSI interface card.
t# identifies the target address of the SCSI disk.
d# identifies the SCSI lun address (0, except for disk arrays).
The device file should have its protections set to read and write for owner
and group.