HP C100/110 - Manual (Page 164)

148
Changing Your Workstation’s Hardware Configuration
Installing an EISA or GSC Option Board
Graphics Paths
If you are installing a graphics option, read the information in this section
first.
graphics0 through graphics2 are not supported. If the configuration value is
set to “default” (graphics 0), the system console will be graphics 3, Slot 3.
graphics3 Graphics device in slot3. If there is a Dual Graphics Card in slot4,
this is the port to the right on the card when facing the back of the worksta-
tion.
graphics4 Graphics device in slot4. If there is a Dual Graphics Card in slot
3 or 4, this is the port to the left on the card when facing the back of the
workstation.
NOTICE: If you install a VISUALIZE-48 graphics card (geometry accelerator board
installed in slot 3 or slot 4) the system path is graphics 3.
If your model C100/110 is running HPUX 9.05, the system console
graphics device must be installed in Slot 3.
If your model C100/110 is running HPUX 9.07 or later, the system will
find a console graphics device installed in Slot 3 by default. You may
install the console graphics device in Slot 4 if you modify your system files
as described in HP Visual User Environment Users Guide or HPUX X User
Environment User’s Guide.