beautypg.com

HP C100/110 User Manual

Page 142

background image

126

Changing Your Workstation’s Hardware Configuration

Installing Storage Devices

2

From the rear of the storage tray, line up the disk slides on the CD-ROM or DDS
tape drive with the position 1slots in the storage tray chassis, and slide it into
place, as shown in Figure 26.

Figure 26

Installing a CD-ROM or DDS Tape

3

Push the storage device in until the locking tabs snap into place.

4

Connect the single-ended SCSI-2 data cable and the power cable to the drive.
Refer to the cable routing label on the storage tray.

5

Proceed to the section entitled Replacing the Storage Tray.

CD-ROM or DDS Tape Drive

Cable Routing Label