HP A3312A - Manual (Page 84)

& Diagnostics
Information
78
Troubleshooting
Byte
-13
Description
17 02 Recovered data using positive offset
17 03 Recovered data using negative offset
17 05 Recovered data using previous sector ID
17 06 Recovered data without ECC; data auto-reallocated
18 00 Recovered data with ECC
18 01 Recovered data with ECC and retries applied
18 02 Recovered data with ECC and/or retries; data auto-reallocated
19 00 Defect list error
19 01 Defect list not available
19 02 Defect list error in primary list
19 03 Defect list error in grown list
1A 00 Parameter list length error
1B 00 Synchronous data transfer error
1C 00 Defect list not found
1C 01 Primary defect list not found
1C 02 Grown defect list not found
1D 00 Miscompare during verify operation
20 00 Invalid command operation code
21 00 Logical block address out of range
24 00 Invalid field in CDB
25 00 LUN not supported
26 00 Invalid field in parameter list
26 01 Parameter not supported
26 02 Parameter value invalid
26 03 Invalid field parameter; threshold parameter
26 98 Invalid field parameter; checksum
26 99 Invalid field parameter; firmware tag
27 00 Write-protected
28 00 Not ready-to-ready transition; medium may have changed
29 00 Power-on, Reset, or bus device reset occurred
29 01 Power-on Reset occurred
2A 00 Parameters changed
2A 01 Mode parameters changed
2A 02 Log parameters changed
2F 00 Tagged commands cleared by another initiator