HP 441877-00F User Manual
Page 54
Configuration and diagnostics 54
LOAD Q57 SLOT=2 FRAME=Ethernet_SNAP NAME=Q57_1_ESP
BIND IPX Q57_1_ESP NET=477A35BD
LOAD Q57 SLOT=2 FRAME=Ethernet_II NAME=Q57_1_EII
BIND IPX Q57_1_EII NET=C3C8F2E4
BIND IP Q57_1_EII ADDR=172.16.1.1 MASK=ff.ff.0.0
mount all
SEARCH ADD SYS:\JAVA\BIN
SEARCH ADD SYS:\JAVA\NWGFX
IMPORTANT:
If you modify any adapter parameters, you must reboot the system before the
changes will take effect. If you make changes and do not reboot, you may experience
configuration problems.
Removing drivers from Autoexec.ncf
To remove the drivers from the Autoexec.ncf, locate the LOAD and BIND command lines associated with
the driver and remark them out by inserting the pound (#) symbol at the beginning of each command line.
Example:
# LOAD Q57 SLOT=2 FRAME=Ethernet_802.2 NAME=Q57_1_E82
# BIND IPX Q57_1_E82 NET=FAFD3D25
# LOAD Q57 SLOT=2 FRAME=Ethernet_802.3 NAME=Q57_1_E83
# BIND IPX Q57_1_E83 NET=5A2D8D6D
# LOAD Q57 SLOT=2 FRAME=Ethernet_SNAP NAME=Q57_1_ESP
# BIND IPX Q57_1_ESP NET=477A35BD
# LOAD Q57 SLOT=2 FRAME=Ethernet_II NAME=Q57_1_EII
# BIND IPX Q57_1_EII NET=C3C8F2E4
# BIND IP Q57_1_EII ADDR=172.16.1.1 MASK=ff.ff.0.0
NetWare server driver LOAD line parameters
This following lists the NetWare server driver LOAD line parameter settings for HP server adapters for
N100, N1000, and N1000e.
•
FORCEDUPLEX. This keyword specifies one of the following duplex modes:
o
Auto-negotiate. The adapter negotiates with the switch and hub how to send and receive packets
at either full- or half-duplex speed. If unsuccessful at negotiating the duplex, HP server adapters
default to half-duplex. You must have an auto-negotiating switch/hub (an Nway switch) to get
full-duplex support with the FORCEDUPLEX parameter set to 0 (auto-negotiation).
o
Full-duplex. The adapter sends and receives packets at the same time. This improves the
performance of your adapter. Set duplex mode to full-duplex ONLY if you have a hub/switch
that supports full-duplex.
o
Half-duplex. The adapter performs one operation at a time. It either transmits or receives. To set
the adapter to half- or full-duplex mode, you must set the SPEED parameter to either 10 or 100.
NOTE:
The HP NC31xx, 340T, and NC71xx Server Adapters support full-duplex and half-
duplex. The HP NC61xx fiber Gigabit Server Adapters support full-duplex mode only and
cannot be changed.
o
Syntax: FORCEDUPLEX=n
Where n =
0—auto-negotiate
1—half-duplex
2—full-duplex