HP 441877-00F User Manual
Page 41
Configuration and diagnostics 41
Property Parameter
Vlan Id
Sets the VLAN ID for this interface (also exposed through the standard OID). QoS
Packet Tagging must be enabled or the VLAN ID parameter is ignored.
•
Default: 0 (no VLAN)
•
Range: 0 – 4095
If multiple VLANs are set, the value is set to 0 (zero) and an intermediate driver is
used to set each VLan.
Configuring an HP NC510x PCIe 10 GbE Multifunction adapter
HP supports a maximum of two HP NC510x PCIe 10 GbE adapters in a single system.
•
Requirements— Each HP NC510x adapter requires 1 GB of system memory, and HP recommends
installing 2 GB of system memory per 10 GbE adaptert. HP systems with this adapter installed
support up to 32 GB of system memory for Windows operating systems (OS) and up to 64 GB of
system memory for Linux OS. Each NC510x PCIe 10 GbE adapter installed must have a unique IP
address assigned.
NOTE:
Windows 32 bit may require the Physical Address Extension (PAE) option to utilize 4
GB or more of memory. PAE is a memory address extension that enables support of greater
than 4 GB of physical memory for most 32-bit (IA-32) Intel Pentium Pro and later platforms. For
more information, see PAE Memory and Windows information on the Microsoft
e.
•
Installing—Install one additional NC510x PCIe 10 GbE stand up adapter in any empty PCI Express
slot on the system. In a Windows or Linux OS, when the NC510x driver is installed, the driver
automatically loads for an additional NC510x adapter that are added.
•
Enabling—Each adapter can be enabled independently. The user assigns an IP address to each
adapter in the system.
•
Disabling—Each adapter can be disabled independently.
Configuring an HP NC512x 10 GbE Multifunction BL-c Adapter
HP supports one HP NC512x 10 GbE Multifunction BL-c Adapter per system.
•
Requirements—HP recommends installing 2 GB of system memory per 10 GbE port. HP systems with
this adapter installed support up to 32 GB of system memory for Windows operating systems (OS)
and up to 64 GB of system memory for Linux OS. The NC512x multifunction 10 GbE adapter must
have a unique IP address assigned for each port.
NOTE:
Windows 32 bit may require the Physical Address Extension (PAE) option to utilize 4
GB or more of memory. PAE is a memory address extension that enables support of greater
than 4 GB of physical memory for most 32-bit (IA-32) Intel Pentium Pro and later platforms. For
more information, see PAE Memory and Windows information on the Microsoft
) website.
•
Installing—Install the HP NC512x 10 GbE multifunction adapter in the HP system and then install the
NC512x driver.
•
Enabling—The user assigns an IP address for each port on the adapter.