HP 441877-00F User Manual
Page 46
Configuration and diagnostics 46
o
Range = Disabled; Enabled
•
Priority and VLAN. Enables or disables the ability to insert or remove the 802.1q tags for priority
and VLAN.
o
Default = Priority & VLAN Enabled
o
Range = Priority & VLAN Disabled; Priority & VLAN Enabled; Priority Enabled; VLAN Enabled
•
Receive Buffers. The size, in bytes, of the receive buffers that the hardware can support. This size is
hardware-dependent and can include data buffers, buffer descriptors, and so on.
o
Default = 256
•
Smart Power Down. (NC110T, NC360x, and NC364T only) Minimizes power consumption by
enabling the adapter to enter a deep sleep mode under certain conditions.
o
Default = Hardware Default
o
Range = Disabled; Enabled; Hardware Default
•
TCP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of
TCP Checksum over IPv4 packets.
o
Default = Rx/Tx Enable
o
Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•
TCP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of
TCP checksum over IPv6 packets.
o
Default = Rx/Tx Enable
o
Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•
Transmit Buffers. The size, in bytes, of the transmit buffers that the hardware can support. This size is
hardware-dependent and can include data buffers, buffer descriptors, and so forth.
o
Default = 512 Bytes
•
UDP Checksum Offload (IPv4). Describes whether the device enabled or disabled the calculation of
UDP checksum over IPv4 packets.
o
Default = Rx/Tx Enable
o
Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•
UDP Checksum Offload (IPv6). Describes whether the device enabled or disabled the calculation of
UDP checksum over IPv6 packets.
o
Default = Rx/Tx Enable
o
Range = Disable; Tx Enable; Rx Enable; Rx/Tx Enable
•
Wait for Link. Determines if the driver waits for auto-negotiation to be successful before reporting the
link state. If disabled, the driver does not wait for auto-negotiation. If enabled, the driver does wait
for auto-negotiation. If this feature is on, and the speed is not set to auto-negotiation, the driver will
wait for a short time for link to complete before reporting the link state.
o
Default = Auto Detect
o
Range = Auto Detect; Off; On
•
Wake on Link Settings. Wakes the computer if the network connection establishes link while the
computer is in standby mode. To wake up a system from an S5 state, PME must be enabled.
o
Default = Disabled
o
Range = Disable, Forced; OS Controlled