HP 441877-00F - Manual (Page 24)

Configuration and diagnostics 24
o Syntax: team=nnnn
o Description: Identifies the team. nnnn=DecimalNumber.
• TX_ECBS_TO_USE
o Syntax: tx_ecbs_to_use=nnn
o Description: Sets number of TX ECBs to allocate per virtual adapter
• VLANID
o Syntax: VlanID=nnn
o Description: Sets team to VLAN mode. Creates MLID edge
HP NC-Series Broadcom adapter diagnostics
Starting the Q57DIAG.exe tests
1. Boot to DOS or the EFI shell.
2. From the DOS prompt or shell navigate to the \APPS\DIAGS\Q57 directory.
3. Type Q57DIAG.exe and press the Enter key. The diagnostic tests run automatically.
Test descriptions
The tests are divided into four groups: Register tests, Memory tests, Miscellaneous tests, and Data tests.
They are identified as group A, B, C, and D.
Group A: Register tests
• A1. Indirect register test
Using indirect addressing method, this test writes increment data into the MAC Hash Register table
and reads back for verification. The memory read/write is done 100 times while incrementing test
data.
• A2. Control register test
Each register specified in the configuration contents are defined as read only bit and read/write bit.
The test writes zero and one into the test bits to ensure the read only bits are not changed and
read/write bits are changed accordingly.
• A3. Interrupt test
This test verifies the interrupt functionality. It enables interrupt and then waits for the interrupt to
occur. It waits for 500ms and reports an error if it could not generate interrupts.
• A4. Built-In-Self test
This test initiates Hardware Built-In-Self-Test (BIST) and then waits for the test result returned by
hardware. The hardware could not generate interrupts.
• A5. PCI Cfg register test
This test verifies the access integrity of the PCI config registers.
Group B: Memory tests
• B1. Scratch pad test
This tests the scratch pad SRAM on board. The following tests are performed: