HP 441877-00F - Manual (Page 30)

Configuration and diagnostics 30
Options Description
-wol <1|0>. Enable (1) / Disable(0) magic packet Wake-on-LAN option.
-mba <1|0> Enable (1) / Disable(0) multiple boot agent.
-mbap Specify MBA boot protocol: PXE(0), RPL(1), BOOTP(2), iSCSI_boot(3).
-mbav <1|0> Enable(1) / Disable(0) MBA VLAN.
-mbavval Specify MBA VLAN value (< 65536)
-mfw <1|0> Enable(1) / Disable(0) management firmware agent.
-sn Specify serial number for the card.
-t Disable certain groups/tests (e.g. -t A5).
-T Enable certain tests/groups (e.g. -T A5)
-cof Allow tests to continue tests on failure.
-none disable all tests.
-slave Select device number to be in host loopback mode. The device is simply echoing all
received packets, and not operable for other purposes.
-fbc Specify the bin file for combined boot code.
-fbc1 Specify the bin file for boot code 1.
-fbc2 Specify the bin file for boot code 2.
-fl2b Specify the bin file for L2 firmware.
-fipmi Specify the bin file for IPMI firmware.
-fump Specify the bin file for UMP firmware (Similar to using “nvm upgrade –ump
image>”).
-fmba Specify the bin file for MBA.
-fib Specify the bin file for iSCSI boot.
-fibc Program iSCSI configuration block 0, used with -fib
-fibc2 Program iSCSI configuration block 1, used with -fib
-fibp Program iSCSI configuration utility, used with -fib
-fnvm Program raw image into NVM.
-idmatch Enable matching of VID, DID, SVID, and SSID from image file with device’s IDs.
Used with “-fnvm ” only.
-F Force to upgrade image without checking version.
-fmac Specify a file that contains the MAC addresses to be programmed.
-cfgchk Check NVRAM configuration against the configuration file.
-nvmchk Perform NVRAM image CRC checks
-arg Provide arbitrary arguments to be used by scripts
-pnchk Check part number against input value from stdin
-sysop Run a set of nictests on several cards, with hot-swap between Cards.
-fextphy Upgrade external PHY firmware with ext_phy_image.
-help Prints out this help
Return Codes